1958 to 1991 Full Tie Rod End Replacement Kit w/ Video Instructions

Store > Suspension Products
Fits most model passenger cars. Ponton, Fintail, Coupes, SLs, W108 109, R107, W116, W114, W115,W123 and W126. Does NOT fit the W201 or W124 chassis

Loose steering or wheels shaking at speed. This can often be worn out tie rod ball joints. The joints can be replaced as a DIY project. Watch the video below to see if this is something you want to take on yourself.

1958 to 1991 Full Tie Rod End Replacement Kit w/ Video Instructions
$85.00
SKU:
SRS-TIERODKIT
Free Add-Ons Included:

How to Install New Steering Tie Rod Ball Joint Ends - On Demand Video

Product Details

Why you need need to replace your tie rod ends

This kit includes:

  • 2 right hand thread tie rod ball joint ends
  • 2 left hand thread tie rod ball joint ends
  • 30 minute detailed installation video by Kent Bergsma

This will restore your two OUTER tie rods. These are the parts that usually wear out first. If you are doing this job yourself you wll need to get the car up in the air and remove both front tires. If doing this on the ground use back up safety ( ie Jack stands on both side and leave a floor jack under the car to make sure it does not fall to the ground). Other that a few common hand tools you will need a tool to remove the old ball joints. Just google ball joint removal tool. A good pickle fork and a big hammer usually do the job.

Related Products:

Steering Shock Absorber
$44.95

108 109 111 113 107 114 115 116 123 126 Front Steering Shock Absorber

The heavier cars like the R107, W116, and W126 are particularly susceptible to early failure.

If your steering is feeling a little weak or mushy replace the steering shock absorber. Easy to install on the cross steering link with only two bolts. It comes with instructions for easy installation!

$32.50

All Chassis 1968 to 1991 Front Steering Idler Arm Repair Kit

Next to bad steering gear box this is number one cause of steering looseness

FITS THE FOLLOWING: All Mercedes Chassis 111 113 108 109 107 114 115 116 123 126 from 1968 to 1991 (not applicable for 201 or 124 chassis). This is a very common wear problem on most older Mercedes.

$95.25

116 123 126 Chassis Front Wheel Bearing Replacement Kit - All Models

ALL parts shown for BOTH wheels! 450SE 450SEL 300SD 240D 300D 300TD 300CD 280E 280CE 380SE 380SEL to 1985

If you need everything for your front hub, then this is the best deal. This kit is for BOTH sides. Comes with inner and outer wheel bearings, seal, cap, ground clip, and a tube of FREE HIGH PERFORMANCE synthetic wheel bearing grease.

$105.00

1968 to 1976 W114 W115 Front Subframe Mount Kit

Fits 220, 220D, 250, 280, 280C, 240D, 300D (not W123 chassis) 1968 to 1976

If the front end of your W 114 or W115 sedan or coupe wanders on the road or thunks when you go over railroad tracks, you most likely need to install a new front subframe bushing kit. I see this condition even on real low mileage pristine cars. 

$104.50

All R107 C107 Chassis Complete Front Subframe Mount Kit

This is a MUST DO replacement if you want the original feel of a tight front end on your 1972 to 1989 107.

If the front end of your W107 SL or SLC convertible or coupe wanders on the road or thunks when you go over railroad tracks, you most likely need to install a new front subframe bushing kit. I see this condition even on real low mileage pristine cars.