1976 to 1993 C.I.S Fuel Injection 6-Part Video Training Seminar

Store > KE-Jetronic Fuel Injection Products
6 videos total covers both K-jetronic and KE-jectronic fuel injection system theory and testing. Over 2.5 hours of detailed video instruction - Save $37.65 buying the collection!

It has been over 30 years since the last Mercedes with Bosch C.I.S. fuel injection was manufactured. If you own a 1976 to 1993 Mercedes gas engine with this type of fuel injection, you may have difficulty finding someone to work on your car. In some parts of the country, it may be impossible. No mechanic can successfully work on these systems without extensive knowledge and experience. Most of those mechanics have retired or are retiring.

1976 to 1993 C.I.S Fuel Injection 6-Part Video Training Seminar
$30.29
SKU:
COL-CISTESTING

Product Details

This collection includes the following product(s).
Save $37.65 buying the collection!

So, what is the solution? You must learn how to troubleshoot and repair your fuel injection system. It can all seem so mysterious, but it is not rocket science. With the correct testing equipment and the knowledge gained in Kent's video seminar, you CAN fix it yourself!

For testing equipment, repair parts, and other video instruction please send the related products below:

Related Products:

$58.75

1976 to 1993 CIS Fuel Injection Pressure Tester Partial "Short" D.I.Y Build Kit

This is a do-it-yourself option. Full kit is available below. For both K-Jetronic and KE-Jetronic 6 cyl. and V/8 engines. Build an ACCURATE tester and save $$.

If you own, plan to own, and want to enjoy driving your old CIS fuel-injected Mercedes, Kent highly recommends you learn to do a full fuel system flow and pressure test.

On Demand Video
$16.99

How to Test the EHA Valve on Bosch KE-Jetronic Fuel Injected Engines - On Demand Video

Factory training manual procedure followed step-by-step. You will be surprised by what Kent found on this 560SL engine.

In this 13-minute CIS training video, Kent will walk you through the steps recommended by Mercedes Benz to fully test the operation of the EHA valve on 1984 to 1993 4, 6, and 8-cylinder engines with KE-jetronic fuel injection.

On Demand Video
$8.00

How to Adjust That Troublesome Little Screw on you 1976 to 1993 C.I.S. Fuel Injected Engine That Won't Run or Run Right

Part of Kent's $8 troubleshooting and repair video collection. The video will only cost $8 but you could save $ hundreds and much grief by watching this video.

This video applies to both K-jetronic and KE-jetronic fuel injection engines on Mercedes from 1976 to 1993.. Let's say you just acquired an old gas engined  Mercedes and you just can not get it to run right and or even get it to start.

$8.50

Super Thin 14mm Combination Wrench for CIS Pressure Tester Fittings

For tightening and holding the small adapter fitting that goes into the fuel distributor

When pressure testing your KE-jetronic fuel injection,  you may find you need a really thin wrench to install the small fitting on the right side bottom of the fuel distributor.

$38.00

Fuel Pump Relay Switch Jumper Lead (s) for Pressure Testing K and KE-Jetronic Fuel Injection

VERSION 2: For single and dual fuel pump systems 1976 to 1993.14 feet in length with an on /off safety switch and fuse protection - the pump or pumps with the engine off and your pumps directly connected to your battery.

PLEASE NOTE: Wire color may be all red or all black (depending on stock on hand) Performing some fuel pressure tests on your K-jet or  KE-jet engine