All new 2006 to 2013 V6 and V8 engine repair kits! CLICK HERE to view AlL.
Removing the rear axles from the W201 chassis is not a difficult job provided everthing goes well. In fact, the procedure is considerably simplier than removing axles from the older swing arm rear ends of the 1970's and early 1980's.
Does your rear end make funny noises while driving? Does the rear of your car sag in the back? Do you have excessive rear tire wear? Does the rear of your car feel like it is moving around? During heavy braking or rapid acceleration does your Mercedes want to steer right or left on its own!
If you have one of our pressure brake bleeders, you can easily attach this wand to the end of the hose by removing the brake master cylinder reservoir cap. You can place the exact amount of fluid in the tank, hang the wand in the fill hole, lock the valve open, and walk away.
This tank works amazing! Put in the heavy rear end or trans fluid. Pump up the pressure. Stick the non-fall-out end in to fill hole... and just push on the valve in the handle of the filling wand.
Have you dreaded changing the rear end fluid before because it is a pain and ends up being really "messy?" Kent finally decided there had to be a better way so he went to work and came up with the idea of using a simple and affordable custom made pressure tank to "flush" and refill differentials
Works on W114, W115, R107, W116, W123 and W126. A better performing and more comfortable 14mm hex wrench to use when changing the fluid in your rear end. Will work on manual transmission with 14mm drain plug only. Watch the video to see why.
Wheel bearing maintenance and service should not be neglected. If you are hearing strange rumbling noises up front while driving you should check your wheel bearings. Replacing them is not a diffiuclt D.I.Y. job if you have the right knowledge and tools.
This is not a normal nut. On the face it has a special hard plastic nylon seal. When this seal deteriorates you may see evidence of power steering fluid seeping out of the bottom the the adjustment locknut (located on the top of the steering box).
This important rubber coupler connects your steering column shaft to the steering box input shaft. Inspect yours for cracking now. Always replace when replacing steering gear box.
The Mercedes Multi-Link rear end is a marvel of engineering and works extremely well, but when one or more of the link bushings wear out, your car will start steering on its own! In severe cases when applying rapid power it may act like it wants to change lanes on you.