If you own a 1998 to 2006 Mercedes with a V6 (M112) or a V8 (M113) engine this is one job you will have to deal with at some point. Just pull the top cover off your engine and look. Even cars with low mileage may have oil seeping out the breather covers on the top of the heads. Doing a proper reseal on these covers is not hard but it is tedious if you don't want them to leak again. This is one job if you want it done right you should consider doing it yoursel!!!
Product Details
Even more so than needing the correct sealant, you will need to make sure the sealing surfaces are ABSOLUTELY clean of any dirt, oil, or moisture BEFORE you apply the new CORRECT sealant. This kit contains supplies and instructions on how to do just that.
- Tube of MB approved correct black sealant in a syringe applicator
- 5 new stainless steel bolts to replace aluminum bolts
- Pack of 6 plastic razor blades (for 1st phase of cleaning)
- 1 special nylon brush
- 2 acid brushes (for 2nd phase of cleaning)- that you can custom cut
- 1 piece of scotch brite purple pad
- 1 rough nap red shop cleaning rag (for 3rd phase of cleaning)
- Detailed video instructions
Kent's instructional video on doing this repair to just one cover on one side is 36 minutes long! This video is free of charge when you buy this kit. In this video Kent removes the right side breather cover on a W220 S500 and takes you through the process step by step to fixing the leak properly.
PLEASE NOTE: The replacement stainless steel bolts in this kit are the correct metric thread and length. Rather than a torx head the bolts had a 5 mm hex head. Please note this when preparing the tools you will need to complete the job. The bolts holding the covers in place should be torqued to the proper specs and Kent outlines in his video. Kent prefers the beam style torque wrench ( see below ) for accuracy on the very low torque bolts.
Related Products:
M112 V6 Complete Breather and Valve Cover Oil Leak Repair Kit w/ Video Instructions.
Kent and others have seen valve cover leaks return within a few years after resealing. Some feel this may be a design flaw, but I contend the job was never done right in the first place. Let Kent explain why the leaks come back...
M113 V8 Complete Breather and Valve Cover Oil Leak Repair Kit w/ Video Instructions.
Kent, as well as others, have seen valve cover leaks return within a few years after resealing. Some feel this may be a design flaw, but I contend the job was never done right in the first place. Let Kent explain why the leaks come back...
1/4 Inch Drive Beam Type Super Low Torque Wrench
If you are tired of "guessing" on those critical low torque settings maybe it is time to get a small torque wrench. This is the one Kent likes for super low torque settings up. It is quality made and will not cost you an arm and a leg. You can even calibrate it yourself!
1998 to 2006 M112 V6 M113 V8 Power Steering Fluid 40K STANDARD Service Kit
For 2000 to 2006 chassis only mentioned in the title. Power steering reservoir is NOT for
M112 V6 M113 V8 U.S ( Not AMG or Euro Spec ) Breather Hose Replacement Kit w/ Video Instructions
For most U.S. V6 and V8 engines from 1998 to 2006 with mass air flow sensor at the back center of the engine.
WILL NOT FIT AMG ENGINES.
1998 To 2006 M112 V6 Engine Valve Cover Gaskets
Gaskets only here. If you need instructions or other parts related to valve cover removal please see related products below.