If you are going to pull your transmission to replace any clutch components you should do it right! That means to replace all key wear components so you don't have to remove the transmission again any time soon. Go with the best so the repair will last the longest. That means high-quality parts only. If you have a 1980 model you need to make sure you have the later vin number.
Product Details
- New Sachs Pressure Release Bearing
- New Input Shaft Center Bearing
Sorry but no instructions are available at this time.
NOTE: To confirm the correct pressure release bearing your transmission should have the three shift rods connected to the BOTTOM of three shift levers pointing DOWNWARD. Earlier transmissions had the shift levers pointing upwards.
Related Products:
220D and 240D Clutch Pressure Plate and Disc by Sachs
SPECIAL ORDER ONLY -- If you are going to pull your transmission to replace any clutch components you should do it right! That means to replace all key wear components so you don't have to remove the transmission again any time soon.
1968 to 1979 220 230 220 and Early 240 Clutch Release Bearing and Pilot Bearing.
If your clutch is making growling noise when you push the pedal in these are the parts you need to fix it. You might want to consider replacing the pressure plate and disc while you have the transmission out.