W126 Brake Control Rod Joint Long Attachment Bolt - USED

Store > W126 > Suspension Products
Not included in new parts kit. You may need only if you have to cut the old one off due to extreme rust

This long bolt washer are is available new. When replacing the Brake Control Rod Ball Joint Bushing on the W126 chassis this long bolt has to be removed. If severely rusty you may have to cut off with saws all. The long bolt is not included in the repair parts kit. This is intended if you need the whole part with the big waster and nut clip as shown.  If you only need bolts you can purchase those new. See related products below:

W126 Brake Control Rod Joint Long Attachment Bolt - USED
$22.50
SKU:
USED-126BRJBOLT

Product Details

Related Products:

$129.50

126 Brake Control Rod Ball Joint Bushing Kit (Guide Rod Mounts x 2)

#1 Front suspension wear point on ALL 126 Chassis from 1981 to 1991

PLEASE READ THE ALERT BELOW BEFORE ORDERING. If your 126 sedan or SEC coupe is making front end clunking noises when you brake or go over bumps at slow speed you most likely need to replace the bushings where the lower front suspension guide rod attaches to a body subframe casting.

$16.80

W126 Front Suspension Brake Control Rod Bracket Long Bolts

You may need to replace these if yours are very rusty. They do not come in the joint repair kits.

These are the 4 long bolts that need to be removed when changing your W126 brake rod control joint on your front suspension. There are two on each side. They do not come in the repair kit so if you bolts are very rusty you might want to have these new bolts on hand before you start your repair.